Att Uverse and Deco
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Att Uverse and Deco
Model :
Hardware Version :
Firmware Version :
ISP :
I did some searching and was a little surprised I could not find this answer. I am getting ready to install a Deco behind a Uverse Modem/Router. I am really using it for the parent tools, so it doesn't look like I can use it as an access point. Is this correct? Does anyone know if I need to change the Uverse router to bridge mode, and have Deco be the sole router in the network, or can I just push all data to the first Deco device? Thanks for the help!
Hardware Version :
Firmware Version :
ISP :
I did some searching and was a little surprised I could not find this answer. I am getting ready to install a Deco behind a Uverse Modem/Router. I am really using it for the parent tools, so it doesn't look like I can use it as an access point. Is this correct? Does anyone know if I need to change the Uverse router to bridge mode, and have Deco be the sole router in the network, or can I just push all data to the first Deco device? Thanks for the help!