AX6000 IPv6 not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX6000 IPv6 not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AshT3

2020-04-30 17:53:39

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-04-30

AX6000 IPv6 not working

2020-04-30 17:53:39

Model: Archer AX6000

Hardware Version: V1

Firmware Version: 1.0.7

Noticed yesterday that my IPv6 is not working correctly. When set to Dynamic and connected to my Xfinity router, all appears fine except that IPv6 sites will not load. When I run a IPv6 test, it replies that I do not have an IPv6 ip adress. I changed the setting to PassThrough(Bridge) and all works fine. I know that this is not the way that it is supposed to be setup, but cannot find a way around. Any help to resolve the issue would be great.

2 Reply

ArcherC8

LV5

2020-04-30 18:51:33

Posts: 2101

Helpful: 835

Solutions: 49

Stories: 0

Registered: 2018-11-05

Re:AX6000 IPv6 not working

2020-04-30 18:51:33

I had to try different settings to get IPv6 to work from my ISP (Comcast). Each ISP may be different. I used WAN connect type DHCPv6, Get IPv6 prefix delegation on, Get IPv6 DNS Server Automatically on, IPv6 Address Assign Type SLACC, and IPv6 Address Prefix as :: and got it to work. Be sure to hit the save button. I may have also powered cycled the router also which I tend to do after making changes. Hope this helps.