WiFi Calling Deco Mesh
I have recently installed the deco mesh and it's working well. However, I can no longer use WiFi calling on my phone. This has only been the case since I installed the mesh. Any ideas?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Try port forwarding to see if communication is being blocked.
Find the IP address that the phone has, and then forward the ports 500, and 4500, setting protocol to "All".
Here is a FAQ that will show how to do that: https://www.tp-link.com/us/support/faq/1797/
- Copy Link
- Report Inappropriate Content
@Tony I am really struggling with this, I have followed all instructions but it just doesn't seem to be working for me.
I LOVE my deco but I really need this to work, for my job. Any chance you could provide a little more info!?
Thank you.
- Copy Link
- Report Inappropriate Content
With port forwarding, every device or service is different so the first thing to look up is what ports that are used.
Now if the Deco is connected to another router, say your ISP router, then you will also need to do port forwarding on your ISP router too.
For example, say you have the following:
ISP Router > Deco (router mode, by default) > Device (uses port 80)
Deco: forward port 80 for Device
ISP Router, forward port 80 for Deco
So just like how you need to forward ports in the Deco for the device, the same concept, just shift it over, now you need to forward in the ISP Router for the Deco. Within the ISP Router, you will check what IP the Deco got from it, and create port forwarding rules for that IP.
- Copy Link
- Report Inappropriate Content
Hi Tony,
I am using an iPhone 12.
Honestly this is far far beyond any limited knowledge that I have.
Does this article make any sense for you?: https://support.apple.com/en-us/HT203609#:~:text=TCP%20port%20443%20is%20used,reach%20APNs%20on%20port%205223.
Thank you so much in advance for your help!
Josh.
- Copy Link
- Report Inappropriate Content
The article you mention seems like that is with respect to push notifications so the icons you get above your phone.
I looked around and apparently, Apple uses the following ports for Wi-Fi calling:
UDP 500
UDP 4500
You can contact your phone carrier just to confirm.
However, I would recommend reaching out to your local support team (link), and informing them you need to do port forwarding for your phone and reference the two ports above.
- Copy Link
- Report Inappropriate Content
Is there a way to open the external port with forwarding to a signle device. (i.e. multiple cell phones)
- Copy Link
- Report Inappropriate Content
If a device was behind the Deco, and you wanted to open that devices port to the internet so multiple devices can connect to it, is done by using the port forwarding guide: https://www.tp-link.com/us/support/faq/1797/
- Copy Link
- Report Inappropriate Content
First, I have installed the Deco x60 with two satellites a couple of months ago. I am very pleased with it.
Once I learned to turn off the 5 Ghz signal when I wanted to connect various switches, I got everything up and running.
However, today I decided to remove my T-Mobile Cellspot since I had the Deco network working well.. This device uses a wired connection to my router via a switch.
Before removing the cellspot, I had 5 bars, after removing I dropped to two bars. My phone is a Samsung A32 which is pretty new. I reinstalled the cellspot and am back to five bars.
Is a mesh system set compatible with wifi calling?
Thanks
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 7635
Replies: 8
Voters 0
No one has voted for it yet.