M4 Set up as Access point with Ethernet
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
M4 Set up as Access point with Ethernet
Hello,
I am trying to set up the M4s as an access point to my current Wifi. I have both units connected Via Ethernet but the slave node always shows connected from Wifi. Is there a way to keep them both connected by Ethernet and just use them as only extenders from my Main router? Also my speeds on either units is around 70UL and 70DL , I have Gigabit service and even on my typical Wifi im getting about 400UL and 400DL. Is there a setting I can switch to improve my speeds?
