The issue over Ethernet backhaul on deco m4
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
The issue over Ethernet backhaul on deco m4
Hello, i have 2 deco m4 and 2 w2400. first two of them I have installed as wireless, then I want to add 2400 as a third device, where I want to add in this room there is a good signal also a good wireless signal from my deco wifi network, but I want to add a third via Ethernet backhaul.
How do I know if the third device is connected via Ethernet cable or via wireless? how? How can I be sure that I add a third device via cable? i connected the cable from the main deco to the third device.
Re:The issue over Ethernet backhaul on deco m4
Hi, welcome to the community.
You could check the Mesh Backhaul type here:
"Living Room" Deco is on Ethernet Backhaul.
best regards.
▶Deco BE11000/ BE63_V2.6_1.1.7 Ready for Test
▶Deco BE25_V1_1.0.17 Ready for Test!
▶Deco M5 Newly Introduced Advanced Parental Control Features
Try to leave a Message if urgent help is required.
