New router not allowing camera NVR to connect

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

New router not allowing camera NVR to connect

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
New router not allowing camera NVR to connect
New router not allowing camera NVR to connect
2023-10-19 00:50:46 - last edited 2023-10-20 02:21:23

Installed a new Archer AX21 router after ditching a Netgear Nighthawk that was acting up. It puts out good WiFi and my devices can connect, but one thing I noticed is my Lorex camera system that is ethernet wired to the back of the router is not connecting to the internet. I can't view my cameras remotely. What should I check? I don't remember doing anything special on my old router for them to work. I've updated the router to latest firmware, reset the router, reset the camera's NVR. Thanks

  0      
  0      
#1
Options
1 Reply
Re:New router not allowing camera NVR to connect
2023-10-20 02:06:49

  @Theskater101388 

 

most likely you need to reserve an ip address for the nvr such as 192.168.x.x where the x is in your pool range and then set up port forwarding. Look at your existing nvr or old router settings which may help you determine which ports to set up. 

  1  
  1  
#2
Options

Information

Helpful: 0

Views: 582

Replies: 1

Related Articles