AXE75 unable to find Ring camera
I have an AXE75 as my main router. I configured a reserved IP address for my Ring camera (floodlight pro).
When the Ring camera connects to an access point I have (wired to the main router), and then connects back to the AXE75, the Ring camera can no longer be found. Pings fail, ARP requests to find the cam fail, etc.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
What's your access point model ? You have to give more details about your network topology and configuration.
- Copy Link
- Report Inappropriate Content
TP-Link AXE75 is main router, connected to ISP provided modem. The AP was a Netgear R7800 in AP mode, wired to the main router. I also added a TP-Link BE550 in place of the R7800 and the same thing happened. When the Ring cam (connected to the main router) is connected to another AP, and then re-connected back to the main AXE75, at that point going forward, no device on the main network can 'find' the Ring cam -- because there is no response to ARP queries trying to find the mac address of the camera ip address.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
The modem is just a modem (not a router).
Just confirmed that this is a bug with the AXE75. The AP is not needed. The new test procedure is:
- Confirm Ring cam responds to ARP
- Put Ring cam into setup mode (causes cam to disconnect from Wi-Fi)
- Exit Ring cam setup mode (causes cam to reconnect to Wi-Fi)
- clear test PC ARP cache and confirm ARP cache is clear.
- Check if cam responds to ARP to find cam
This procedure WORKS with:
- TP-Link BE550
- TP-Link AX80
- Netgear R7800
but this procedure fails with the TP-Link AXE75.
- Copy Link
- Report Inappropriate Content
I think your troubleshooting steps will be of use for TP-Link teams.
You can contact your local tech support to report this.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 655
Replies: 5
Voters 0
No one has voted for it yet.