Range Extenders
Welcome to the TP-Link Range Extender forum. This is a dedicated space for discussing how these devices help eliminate Wi-Fi dead zones and expand your wireless network. Join the community to ask questions, contribute solutions, and explore practical strategies for optimizing your Wi-Fi coverage.
Range Extenders
I recently bought a TP-Link AC1200 Wifi Extender (RE305) for my home. I got it connected to the router and have all the blue lights across the top. However, on my phone I keep getting an alert on my w
By
PleaseHelpMe
· Latest post 2022-05-08 16:29:21
by Vamisof
996Helpful
772156Views
This Article Applies to: Dual-band range extenders, such as RE200/RE220/RE300/RE450 Host Router related: Verizon Fios Router G1100/G3100 If your TP-Link range extender randomly drops the 5Ghz connecti
4Helpful
7698Views
We often receive questions relating to the setup, recommended configurations, and compatibility of TP-Link devices with a Starlink Network. Archer Routers, Access Points, Range Extenders, and Deco Mes
2Helpful
28061Views
I have a TP-Link RE605X, and currently I can only access its recovery page through 192.168.1.1. However, whenever I try to upload the official firmware, it shows an “upload failed” error (see attached
By
iceseahgost
· Latest post Thursday
by iceseahgost
0Helpful
65Views
What range in and out of extender should I expect
0Helpful
47Views
Yesterday: I installed an Archer BE550 router replacing a nighthawk. My wife's office wasn't getting great signal (exact opposite side of the house) so I ordered a RE1500x to do the Easy Mesh thing. (
EasyMesh
0Helpful
704Views
I just got my unit and set it up to do a range extension of both my 2.4GHz and 5GHz WLANs. These are on different subnets and I'm using the SSIDs with the _EXT suffixes. When connected to either of th
3Helpful
181Views
Hi, I am unable to change the name of the device via the app iPhone. I follow the instructions and hit save but nothing happens. Is a reboot required or is the app not working properly to change the n
1Helpful
181Views
I have a RE2700 V1.6 Extender that is wired to my BE800 router and it only works correctly in Access point mode. I am unable to use it as a mesh device like all my other Extenders. I also notice that
Access Point ModeFirmware UpdateEasyMesh
0Helpful
51Views
I changed router and I reset TP. Someone alse installed it a couple years ago and it was working not crazy fast let say but fine. Anyway I had no clue what is my pass or fv or hv. After reset network
0Helpful
215Views