HS-220 Smart Switch Dimming Issue
HS-220 Smart Switch Dimming Issue
My HS-220 dims fine when NOT connected to the internet. When connected to the internet, my lowest dim range is much brighter than when not connected to the internet.
Any help will be appreciated.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
You likely need to calibrate the brightness levels within the Kasa app. With the Kasa app opened, go to devices, then tap on the name of the HS220. Go into device settings (top right icon), and scroll down to the Advanced section, and select "Dimming Calibration". Set your desired brightness levels in that menu.
- Copy Link
- Report Inappropriate Content
I have a related issue. I would like to decrease the brightness level at the lowest dimmer setting. I have used the Dimming Calibration but the lights never dimmed as much as I wanted them to. It never got to the point where they would flicker or cut out. Some advice would be appreciated.
- Copy Link
- Report Inappropriate Content
Similar issue: just installed the HS220, and it connects fine to network and turns off and on through the network, but zero dimming effect with LED load. Full bright all the time. What's up with that?
- Copy Link
- Report Inappropriate Content
@Andreww What is the firmware version you are currently running with the smart switch?
@mooneysmith What is the model of the LED bulbs you are using?
- Copy Link
- Report Inappropriate Content
Firmware version 1.5.7
- Copy Link
- Report Inappropriate Content
Sorry for the late response. Please let us know if you are still having issues with your HS220. There have been recent updates to the App and may also have been an update released for the Switch. If you are still having issues it would be helpful for some screenshots of what you are settings are. We can forward this information to our development team to see if we can improve your experiance.
- Copy Link
- Report Inappropriate Content
@BigJoe I just bought an hs-220 and I have exactly this same problem.
When installing, when disconnected from the internet, the dimmer had a way lower range (like my previous non-smart one), which is what I like. As soon as connected, the lowest setting is way brighter than the lowest setting when not connected (I'd say the range is about 40% to 100% only).
Is there any fix for this?
EDIT: Just fixed it.
1) Remove the dimmer from the Kasa app, it will disconnect from the internet
2) Go to the dimmer, turn it on and manually set it to the lowest setting. You'll see that it goes low enough.
3) Keep it in the lowest setting and add the device back to Kasa app.
4) Do the calibration and this time it will access the correct range.
I guess it failed the first time during instalation because the firmware wasn't updated yet.
- Copy Link
- Report Inappropriate Content
@BigJoe It isn't Intuitively obvious, but the calibration occurs within the app itself under the device settings - calibration. When in the calibration mode, the slider is not an up and down slider, but a tap on top or tap on bottom of the "slider" depiction/control to make the light brightness go up or down. Again, this calibration is performed within the app.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@skyb It is about dimming possibility for low level light.
I have dimmable LEDs, and without Kasa app I can go down to real 1%. But with app when I adding the device, the minimum level is jumping after calibration to 25%, it is no difference between 1% and 25% anymore. I cannot get the REAL 1% of the brightness with the app.. It is software and how to fix it?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 8450
Replies: 13