Kasa HS210 indicator and app not correct

Kasa HS210 indicator and app not correct

Kasa HS210 indicator and app not correct
Kasa HS210 indicator and app not correct
Yesterday
Model: Kasa HS210  
Hardware Version: V3
Firmware Version: 1.0.10

The switch will turn on with app and sometimes off after a delay.

 

When manually triggered by the dumb end or the kasa the indicator light with change briefly then comes back illuminated.     The manual press and flip does function the actual circuit on and off.

 

The travelers are 75 ish feet long. 

 

It will not function reliably with the app as the app doesn't see it as on,  so my group off trigger doesn't work.     Night does anytime style 

 

I have reset, restarted , repaired,  

 

I have not tried a second unit at this location as it was my last one to be installed.    I also have not tried a second at the dumb end.

  0      
  0      
#1
Options
3 Reply
Re:Kasa HS210 indicator and app not correct
Yesterday
I just disconnected the switch and confirmed the kasa switch is at the power side of the three-way.
  0  
  0  
#2
Options
Re:Kasa HS210 indicator and app not correct
Yesterday
I measured the length of wire for the runners and they're under 80 feet. I made a one foot section and wired a basic three-way right at the kasa and it works fine. So... Is this thing more sensitive than the 100' they state? Only 0.5 ohms between traveler and common return through the dumb switch.
  0  
  0  
#3
Options
Re:Kasa HS210 indicator and app not correct
Yesterday

I wired the three-way switch and a standard switch so it can function in the app.    If anyone has a solution I'd appreciate ideas.     I think I've exhausted it other than adding a second three-way kasa switch at the dumb end.    Which doesn't make sense but that's the last option I read about that I have not tried.   My issue is it will force new face plates and switches at the current dumb end, so $30 at current 3way kasa, and two decora 3way plus faceplate.    

  0  
  0  
#4
Options