Forums/
Powerline Adapters
2021-01-14 17:41:28
@Theonlyposeidon With the TL-PA8030 there actually is nothing to configure other than pairing them which is used with the pairing button. They do not get an IP from the router as they only relay the...
0HELPFULS
Forums/
Wi-Fi Routers
2021-01-14 17:36:46
@Nutroll Look below the router and make sure the firmware being used is for the correct region. If the router shows (US) below, then the firmware should have the name (US) as well. Another thing to...
0HELPFULS
Forums/
Wi-Fi Routers
2021-01-14 17:18:49
@Shuang The first thing I would check is the network settings of the printer. The printer might have a static IP address assigned to it that matched the previous router. When setting up your printer...
0HELPFULS
Forums/
Deco
2021-01-14 16:46:55
@wifinovice You can have the Deco used the same SSID you have, but note that having the same name does not mean everything will be mesh. When you are around the Deco units, the nodes will recommend...
0HELPFULS
Forums/
Deco
2021-01-14 16:41:12
@JohannH You could possibly try going here: https://global.sitesafety.trendmicro.com/ That is what powers the site blocking feature so you can enter that site, and see about requesting to reclassify...
0HELPFULS
Forums/
Deco
2021-01-14 16:38:16
@MummaJ1. Your Deco will be fine and boot up again without needing to configure again. Should the main Deco not have internet after booting up (red LED), I would just reboot only the internet modem,...
0HELPFULS