Smart Home Community

just purchased and used WPS to connect to router. lights show that 2.4 GHz and 5 GHz are lit/connect to router, but only 2.4 GHz displays on all devices. what am I missing to do so that the 5 GHz disp

wifi handover, AP mode, same ssid

- I have a proper router connected to the ISP, used for DHCP and Default GW - To that router comnects a 32 ethernet port dumb switch. - to that switch there are 9 ArcherAX72, AX72Pro, AX73 and the new

Hard Reset of TL-SG1005P

The default admin user account does not grant me access. How may I factory reset a TL-SG1005P switch for access to the web-based user interface?

assigning manual ip address to printer

My HP printers are constantly dropping offline. HP tech suggests that the router may be changing the ip addresses of the printer, and suggests that I set up a manual ip address for them. Can you give

Archer BE230 Led Controller DEBUG [1904] Failed to read USB3

Only getting USB2 speeds on usb share with wired connection. Have tried with multiple drives. Archer BE230 v1.26 with latest firmware Led Controller ERROR [1904] Config importing failed Led Controller

Wi-Fi speed

Just received my new Wi-Fi router yesterday, did the firmware update I believe and got everything setup and loaded. The problem I see is the speed as it is. Much lower then my previous Linksys router.