Routers Forums - Business Community

Trying to connect a tp-link TL-R605 router to a century link ActionTech C3000. Followed Century Link suggestions: physical connection between WAN port on TL-R605 to a non-wan port on the ActionTech. S

By DQP · Latest post 2021-10-27 03:58:22 by DQP

0Helpful

1167Views

5Replies

TL Er7206

Hi I am facing some odd behaviour on this dual wan router Internet was down, which i thought should be low possibility. I have 2 internet providers after all plugged into the router. In the browser ba

By Einnaro · Latest post 2021-10-25 10:09:07 by Virgo

0Helpful

722Views

1Replies

Configuring 7206 for NAT and access control in multi-IP/multi-server environment

I just bought an ER7206 to replace a failing NetGear router. From what I can see so far, it looks like it will be a very tedious and convoluted operation to configure it to match what my NetGear route

By npowroz

1Helpful

1735Views

0Replies

How to configure Multiple VLANs on the WAN port

Hello My ISP delivers voice and data on two VLANS - VLAN100 (data) and VLAN660 (voice). From ER605 configuration, I can terminate VLAN100 with PPPoE for the data connection. However, I need to switch

By tellanand · Latest post 2021-10-23 13:03:01 by tellanand

3Helpful

3762Views

8Replies

Looking for a pure EVDSL modem (bridge mode)

Hi there, I have configured a LAN for my B&B with EAP access points and a TL-470T+ as my main router. Now (finally) time has come to connect it to the Internet. I have no other router on the network a

By aFunkyBass · Latest post 2021-10-22 21:12:23 by aFunkyBass

0Helpful

519Views

5Replies

Load balance and fail over?

I have dual wans setup on my ER605. Can I have Load balancing and fail over function at the same time?

By jir591 · Latest post 2021-10-22 08:04:31 by Yannie

0Helpful

320Views

1Replies

SETUP VLAN

By RK289 · Latest post 2021-10-21 09:37:49 by Yannie

0Helpful

471Views

1Replies

work from home VPN for SMB using built in windows 10 client

Greetings, I'm trying to set up our office to allow select folks to work remotely. Either from home, hotels, or from customer sites. Ideally, we want to use the VPN client built into windows 10 if at

By RandyFowler · Latest post 2021-10-21 03:16:04 by Yannie

0Helpful

297Views

1Replies

WAN2 always offline

I have the following working router 4g: Interface Name Connection Type Connection Status IP Address Subnet Mask MAC Address Default Gateway Primary DNS WAN1 Dynamic IP Link Up 192.168.8.138 255.255.25

By rdv · Latest post 2021-10-21 02:37:43 by Yannie

0Helpful

618Views

5Replies

two router setup -one with VPN and one primary

I purchased a ER605 to setup as VPN only router and want to connect to existing TPlink c7 Archer router, which is connected to internet. Also, enabled the VPN passthrough for all PPTP traffic in the p

By marc100 · Latest post 2021-10-20 13:54:47 by marc100

0Helpful

431Views

2Replies