Routers
TP-Link Business Routers including Omada and SafeStream VPN series are designed for small and medium-sized enterprises demanding a flexible and secure VPN network. Anything related to TP-Link's Omada Routers or SafeStream Routers, welcome to ask questions, join discussions and share your experience/ knowledge here.
Routers
Dear Team In a Typical Tplink Router i have noticed that an Online Detection keeps a backup wan offline until a failover is detected. This setting depends on the link backup of primary and backup link
WAN SetupLoad BalancingRouting
4Helpful
325Views
Hi! I want to setup a dual WAN system in my home/business because of ISPs stability problems. I'm considering the ER605 or ER7206. Currently, the modem is connected to 1 Archer with automatic DHCP, an
Load BalancingDHCP ServiceRoutingPresales
4Helpful
200Views
So here's is the Topology, basically ER8411 is being utilized as a Load Balancer and not as a Router. The issue is that every 5 minutes a packet or two is getting dropped. I've pinpointed that it was
Load Balancing
By
pines_2600
· Latest post 2025-01-13 08:36:54
by pines_2600
2Helpful
252Views
I am using an ER605 without a controller. My network setup is as follows: WAN: Zyxel FWA710. Setup with Dynamic IP. FWA is setup in IP Passthrough Mode. WAN1: Sky SR203 FTTC. Also setup with Dynamic I
WAN SetupLoad BalancingRouting
1Helpful
277Views
I have two Starlink connections on a fam, about 500 meters apart. I have to cover the farm area with wifi. Is there any way to use both Starlink connections with load balancing feature? What devices w
WAN SetupLoad Balancing
2Helpful
277Views
I am planning use my TL-R605 for using multi wan with different isp and bridge lan is this proposal is possible? EX: ISP 1 (Bridge) going to LAN 1 (Single ISP) ISP 2 & 3 (Bridge&Dynamic) going to LAN
RoutingLoad BalancingWAN SetupVLAN & Multi-Networks
0Helpful
306Views
ER706W-4G Wan 2 always disconnect and intermittent connection. when I Change to ER7206 v2.20 it's works fine and no problem with my internet connection. I tink there is a problem in the firmware.
WAN SetupFirmware UpdateLoad BalancingController
By
Eduard123123
· Latest post 2024-12-02 03:44:30
by Clive_A
1Helpful
284Views
Hello everyone, I have a TP-Link Omada ER8411 configured with 4 fiber optic lines of 1 Gbps connected to the WAN ports. Each line, when tested individually and at different times, reaches around 900 M
Load Balancing
By
est3ban129
· Latest post 2024-12-02 01:47:38
by Clive_A
2Helpful
502Views
Hello, I have an ER605 V2 connected to 3 CPE710 V1 WAN devices at a location. I want my ER605 to do first Online Detection with RX Rate detection (ie: >10.0Mbps) and Load Balancing. Sometimes due to w
Load BalancingBandwidth ControlNetwork ConnectivityWAN Setup
1Helpful
361Views
Hi, I am using an ER605 as the main router on my home network in a multi-wan setup. -wan 1 is connected to a fiber internet modem -wan 2 is connected to a 5G modem wan failover in is place: only wan 1
WireGuardLoad Balancing
1Helpful
344Views