TP-Link Community > Tapo Smart Camera > Changing router NC450
< Tapo Smart Camera

Changing router NC450

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Changing router NC450

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Changing router NC450
Changing router NC450
2019-06-02 18:03:33
Model: NC450  
Hardware Version: V1
Firmware Version: 2.0

How do I change the WiFi on my camera if I change my router? Do I have to delete the camera and start again?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Changing router NC450
2019-06-04 05:49:30

If you don't want to delete the camera, please refer to the instructions in the link below to connect a Wi-Fi network in the web interface. 

 

https://www.tp-link.com/en/support/faq/820/

 

The instructions are suitable for NC450.

 

If you are not able to get into the page or cannot connect the camera to your new Wi-Fi network, please try to delete it from the APP and add it again. Please note that, once the camera is deleted from the TPcamera APP, it will be reset to the factory default. 

 

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Introducing AI QoS: Elevate Your Gaming Experience on the Archer GE800 Gaming Router! Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1925

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.