@Wayne-TP I have the Tapo app on both my iPhone and iPad. When I tried to log into the Tapo app on my iPad ( iPhone wasn't at hand ) to add plugs for Xmas lights it wouldn't recognise myID and...

jonasced wrote @Wayne-TP The vacuum says "Firmware updating, please wait" when I attempt to turn it off, regardless if I hold the power button 3 or 5 or more seconds. Is there anything else I can do?...

@DrDoom90 How does the temperature change in your case? You may share some screenshots of the temperature report here.

@Leo-Sam @artursocastro Beta firmware has been sent to your devices, you may check it later in the Tapo app and perform the update.

@uebi The hub H100 and most of your sensors do not support the migration feature so far. The sensor T100 in firmware 1.13.0 supports this feature, but hasn't been fully rolled out.

@Ouno The sensor cannot be powered off via software. If you need to deactivate it, physically disconnect the battery -- remove the battery or re-insert the battery pull tab. Button batteries actually...