Deco
I am using TP-Link Deco M4 US version. Version 2. 1. Is there any to monitor what my other connected users are doing on the internet? 2. How to Hide my Deco's SSID?
0Helpful
132Views
Hello, So I am using 3 M9 Plus Decos - all on firmware 1.4.3 Build 20200921 Rel. 42500 The mobile app and the web interface both say I am on the latest firmware. The TP-Link Support page says firmware
By
crizthebard
· Latest post 2021-03-10 23:20:57
by costaolx
8Helpful
1974Views
I've seen others post on forums about this for the M9, but I too am having serious packet loss and latency issues regularly on my home network. Every minute to few minutes, latency will skyrocket, som
3Helpful
3647Views
Hello all. I have the Deco M9 Plus setup in my house with the main deco as a router and the others as satellites. This setup has been good for me and I get good wifi access all over the house. However
4Helpful
1211Views
Hi everyone. I was using my P9 Deco until last weeks without problem. I have fibre 100down 8mbit up. My broadband company router is tplink c7v. Normally I am turning off c7v wifi network I am just usi
3Helpful
1465Views
Hi, I have virgin broadband which runs at 200mpbs. When I watch a video on youtube on my apple or android device, it loads up the adds instantly but then shows me a buffering screen when the video is
0Helpful
562Views
Hello. Please answer question directly: Is it possible to use only one Deco M5 without a wired connection? Just to repeat the existing wifi? Thank you.
By
TheSpringmouse
· Latest post 2021-03-10 02:46:16
by TP-Link
0Helpful
83Views
I changed from on olderer wifi router to the Deco M5 because I had buffer errors from time to time. Now I get all kinds of wierd errors. 2-3 of my apps are not loading, and some websides ex. youtube.c
0Helpful
820Views
Hello, I have recently installed the Deco M4 and currently experiencing some websites where the speed to load is extremely slow. This is not all sites but it seems to be the same url's struggling. The
1Helpful
766Views
Hi, I have installed and configured the deco s4 (MESH). However, my laptop shows Deco, Deco2, Deco 3 and I would like to have this under one name. The deco is currently in router mode. Only beamformin
0Helpful
205Views