Today I ran into an issue which made me almost cringe.. as I hadn't expect this to happen, considering I've been working in the IT networking business for over 30 years.. 

I had recently purchased a Deco M5 mesh set with 3 nodes and setup as AP access points, because I alread have a decent router from my ISP (Zyxel EMG2926). This has been working fine for the last 6-8 weeks and nothing to complain about. 

Last night, for some strange reason my router rebooted and I lost Internet connexion from everywhere, including my wired PC's which I use every day to work from home.. So getting back internet was critical to me and I tried the quick obvious options like rebooting the router and also reseting to factory the router, then reloading the configuration I had on backup.. To no avail, I wasn't able to get an functional internet, still the router diagnostic was able to ping any IP address outside my network.. Since I needed to work and support clients, I disconnected the Zyxel router and put back the Mercku M2 Hive base I had prior to the ISP router and after 5 minutes, was back into business.. (The Mercku is also a Mesh Wi-Fi system with 4 Bee nodes, albeit it wasn't working to my entire satisfaction, thus the purchase of the Deco M5).

Having spend the morning with work, I had hope the issue with the router might have been on the ISP side, so tried to set it back in action. Result was identical and nothing was really working.. Put the Mercku M2 back for the PM as I had a support call and did need internet ASAP.

At the end of the PM I got back to my router and it was so weird that I even tried to reset the Zyxel for the n-th time and start from scratch.. What puzzled me was that it was working if I forced my computer into fixed IP address, and even with DHCP Mac address reservation, the router wouldn't route my requests properly to the internet.. Looking at the IP addresses in the config made me think that router was totaly corrupt and crazy.. The router's IP is 192.168.127.1, but returns 192.168.127.102 as gateway and .254 for the DNS server, which is even crazier..  This is when I started to scan my network for rogue devices with my Android smartphone, but couldn't find anything suspicious. I've a lot of IoT devices and aside of the 3 Deco M5 AP's, there was nothing un-usual. However, the .102 IP address made me tick and look closer at the Mac Address, to finally discover that the main Deco M5 unit (the one connected by Cat5 cable to the switch) was the culprit.

For some obscure reasons my Zyxel router was thinking that the Deco M5 AP unit was the master DHCP on the network, despite TP-Link saying in their documentation that it is not the case when in AP mode.. As a proof, my Mercku M2 router had no issues at all with that and was perfectly handing over IP addresses to all devices.. 

Has anyone run into such a situation with another HW router ? getting conflicting DHCP server mode while the Deco M5 is in AP mode ? 

I fixed my problem my disconnecting the Cat 5 cable temporarly from the switch, rebooted the Zyxel router and voilà.. after it was back as 'master' DHCP, I plugged the Deco M5 back and all was working as before.. But I'm really curious about that strange behavior. 

Any comments are welcome on this.