[Deco M5] Led turns red after restarting device (for whatever reason)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

[Deco M5] Led turns red after restarting device (for whatever reason)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
[Deco M5] Led turns red after restarting device (for whatever reason)
[Deco M5] Led turns red after restarting device (for whatever reason)
2020-11-20 11:14:30
Model: Deco M5  
Hardware Version:
Firmware Version: Firmware 1.5.1 Build20201022 Rel. 66804

Hi everyone,

 

I'm using an Arris type TG2492LG cable-modem/router (known here as a Ziggo ConnectBox) which I want to keep as a Router. (wifi disabled)

Besides the modem router I also use a TP-Link Archer AC1750 (wifi disabled) as a switch for extra LAN ports. (WAN port not used)

 

Two deco M5's are wired to the cable-modem. (the third is wired to one of the other M5's)

Everytime I install the first Deco M5 everything seems to work. Wifi is strong and there is Internet connectivity, but it's running in Router mode.


Ater every reboot the device-led turns red. It happened multiple times after a firmware update or after switching from router-mode to AP-mode.

 

Is this a kwown issue? Any tricks I can use to get all my M5's setup and running in access point mode?

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 300

Replies: 0