Troubleshooting LED loop on Deco/ Deco stuck in solid yellow
This Article Applies to:
All Deco models
Typical Problem Description:
1. One of the Deco units was stuck in constant yellow light mode and was not able to enter setup mode (blue blinking light);
2. One of the Deco units goes into this reboot loop of Solid Yellow > Blinking Yellow > Blinking Blue > Off > Solid Yellow, this cycle keeps on repeating.
If Deco had a solid or flashing red, please have a look at this link: Deco turned red
Troubleshooting suggestions:
1. Please hold the reset pinhole at the bottom of the Deco for 1s and check whether the light could be back to yellow---flashing blue.
2. If the factory reset did not make any difference, please refer to this link to do a firmware recovery:
https://www.tp-link.com/support/faq/2958/
If the issue continues, please comment below with the following information:
1. The model number as well as the firmware version of the Deco;
2. Which problem description is more like your current issue?
3. Have you tried the hardware reset and firmware recovery suggestions? what are the results?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
If you are referring to the same case in this thread, please refer to this suggestion for your situation.
Best Regards
- Copy Link
- Report Inappropriate Content
@Solla-topee Yea you are right. So what can i do? Tell me the solution?
- Copy Link
- Report Inappropriate Content
Hi,
It appears that your Deco is faulty. You can contact your retailer or the local support team to check whether the Deco is under warranty. If not, you can purchase a new router or Deco if needed.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 91726
Replies: 73
