Any special DNS outbound address needed for Tapo camera or app for PiHole
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi!
Recently I installed a PiHole device which acts as a DNS server for my house. All devices in my wifi connect through this DNS Server to resolve their addresses.
Since deploying it, I noticed I cannot connect to my tapo camera using the app on my phone any more.
Can I have a list of which DNS servers the device or app needs to access, so I can add them to a whitelist (it would also be good to have them documented online)
Thank you!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I figured it out, once I added these to the whitelist, it worked
- (\.|^)tplink\.com$
- tplinkcloud.com
- tplinknbu.com
Services and devices will often publish a list of all of the ports and URLs they need to access so that network administrators can whitelist the approved addresses. TPLink / Tapo should publish the same for their devices.
It would look like this:
TP-Link Cameras need to send data using the following ports
* 80
* 443
* 43000
They also need to be able to access the following URLs or WildCards
* Domain1
* Domain2
* DomainB
- Copy Link
- Report Inappropriate Content
Hello @FoxDeploy
Tapo camera does not require a specific DNS server, it usually uses router DNS server or some public DNS servers.
Can you set up and allow camera use router DNS or public DNS server like 8.8.8.8 and see if that helps
To isolate the set-up failure, please check if camera shows up on router (DHCP) client list or if camera get an IP address from router after set up.
Thank you.
- Copy Link
- Report Inappropriate Content
@Solla-topee Thank you for your reply!
I meant are there any addresses that we know the TPLink camera needs access to in order to connect?
For instance if TP Link camera need to send data to *.tp-link.com or *.tapo.net or whatever, this is the information I am looking for :)
- Copy Link
- Report Inappropriate Content
Hello @FoxDeploy
Sorry I do not have the full list of domain and IP addresses that camera uses, even there is one, I do not think that is accessible or open to end users. May I know did camera obtain a valid IP address from router after setup, if so, I could escalate your case to our seniors and see if they have any suggestion.
Can I know your detailed network topology as well? Thank you.
- Copy Link
- Report Inappropriate Content
I figured it out, once I added these to the whitelist, it worked
- (\.|^)tplink\.com$
- tplinkcloud.com
- tplinknbu.com
Services and devices will often publish a list of all of the ports and URLs they need to access so that network administrators can whitelist the approved addresses. TPLink / Tapo should publish the same for their devices.
It would look like this:
TP-Link Cameras need to send data using the following ports
* 80
* 443
* 43000
They also need to be able to access the following URLs or WildCards
* Domain1
* Domain2
* DomainB
- Copy Link
- Report Inappropriate Content
Hello, @FoxDeploy
Glad to hear that you were able to find the blocked URLs and port and sorted that out, thank you for sharing the solution here.
Thank you for your proposal, personally I think it is unlikely to make the domain or ports public, we usually escalate the case and our seniors also need to check that from debug tool and logs.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2250
Replies: 5
Voters 0
No one has voted for it yet.