Vr600 and deco issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Vr600 and deco issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Vr600 and deco issue
Vr600 and deco issue
2022-10-27 21:22:55
Model: Archer VR600  
Hardware Version: V3
Firmware Version: 1.5.0.0.9.1

Hey guys I need someone to help with solving this

I have a vr600 "ac2100" as my modem and surveillance system connected to the ethernet 

And other port eth0 to deco m5

I want to setup vr600 as pure modem to solve double nat

I did the same as the guid provided by tplink 

Advance > internet > mode as bridge and delete pppoe but didn't disable any dchp settings as it's not mentioned in the guid and I have it as 192.168.1.1 

The setup deco m5 as router and choose pppope and put username and password 

And dchp is on main as 192.168.68.1 and same subnet 

But I don't internet after that 

What am I missing?

  0      
  0      
#1
Options
3 Reply
Re:Vr600 and deco issue
2022-10-27 21:23:54
And i want to still have my surveillance system connected to vr600 because deco has two ports only
  0  
  0  
#2
Options
Re:Vr600 and deco issue
2022-11-04 09:46:32

  @MotazAlia 

Have you tried to keep VR600as the DSL modem router and put Deco into the access point?

It could also slove double NAT and the surveillance system will still connect to  VR600.

  0  
  0  
#3
Options
Re:Vr600 and deco issue
2022-11-04 12:35:46

  @David-TP I found a way around by activate dmz for deco ip and some how xbox now says that nat is okay 

But on trace route it still shows double nat

  0  
  0  
#4
Options