Home Network Community > Deco > Topology is shown wrong
< Deco

Topology is shown wrong

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Topology is shown wrong

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Topology is shown wrong
Topology is shown wrong
2022-11-14 09:39:51
Tags: #Deco Ethernet Backhaul #Access Point Mode #Firmware Update
Model: Deco M4  
Hardware Version: V2
Firmware Version: 1.5.5 Build 20220823 Rel. 41353

The last deco(Kitchen) in the chain has a significant speed drop but no latency drop, the app shows this topology but this is not how the devices are wired,this issue started after last firmware update.




The image below shows the true topology

  1      
 
  1      
 
#1
Options
3 Reply
Re:Topology is shown wrong
2022-11-15 06:28:49

  @deco_bhilai 

Hi, Thanks for the feedback.

Can I have more details about the speed decrease on the kitchen Deco? What is the current speed you could get from kitchen Deco( via Ethernet connection or 5Ghz)? How about the original speed?

Since you mentioned the firmware upgrade, Did the Deco App have the correct Topology before the 1.5.5 firmware upgrade?

And would a restart of the kitchen Deco improve the current speed?

If possible, please also help me submit the APP log on the APP:https://community.tp-link.com/en/home/forum/topic/581574?replyId=1132466

Wait for your reply.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco X50_V1_1.8.0 Significantly Expanded the Client Connection Details and Added Channel Selection ▶Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN ▶Deco BE65_V2_1.2.10 New Firmware with Enhanced Stability & Interference Resistance ▶Deco BE75 1.1.0 Added WireGuard VPN, Manual Channel Selection and More Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options
Re:Topology is shown wrong
2022-11-15 08:23:47 - last edited 2022-11-15 09:32:24

  @David-TP 
Hi David Thanks for replying

Yes the topology used to be correct before the update
Also, I haven't checked the connection speed via ethernet at the last node, but near other nodes the speed is as much as the isp allows

I cannot select between 2.4 and 5 Ghz right?, so on the same device standing close to the node should result in a 5Ghz connection and full speed right?

 

near 2nd node(Study)

 

 

and near 3rd node

 

 





 

  0  
  0  
#3
Options
Re:Topology is shown wrong
2022-11-15 09:49:06 - last edited 2022-11-15 09:52:31

  @deco_bhilai Also I've sent the email as you asked

  0  
  0  
#4
Options

Information

Helpful: 1

Views: 1050

Replies: 3

Tags

Deco Ethernet Backhaul Access Point Mode Firmware Update
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.