Problem arising after recent firmware update. 1.5.0 Build 20240329 Rel. 61026
Problem arising after recent firmware update. 1.5.0 Build 20240329 Rel. 61026
Hi,
I updated the firmware for my Deco S7 last night and since then all my wifi connected devices are getting max 1mbos against 100mbps isp line. Hard line connected devices do not have any problem. Just Deco S7 mesh is not working. My assumption is that recent firmware update could be causing this. Any ideas to fix the issue?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Mine also became unstable.
I managed to resolve issue at hand by deleting my existing network and reinstalling the Decos again.
Hope it works for you.
Best Regards,
G Arora
- Copy Link
- Report Inappropriate Content
@G_Arora Mines become unstable after upgrading to version 1.5.0 😢
- Copy Link
- Report Inappropriate Content
Hi,
Mine also became unstable.
I managed to resolve issue at hand by deleting my existing network and reinstalling the Decos again.
Hope it works for you.
Best Regards,
G Arora
- Copy Link
- Report Inappropriate Content
Hi, Thanks for the feedback.
Can I have more details about the disconnection issue after updating to 1.5.0?
Could you please refer to this link to help me which case is quite like yours, the third one?
Fix unstable connection when connected to the Deco network
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Thank you all for your help.
I performed a factory reset and recreated the network, but it didn't resolve the issue. Most devices continued to disconnect intermittently.
However, I have now gone 24 hours without any disconnections. I noticed some IPv6 errors in the system logs, so I disabled IPv6.
I hope this has really resolved the issue; IPv6 is not that important to me.
Thanks!
- Copy Link
- Report Inappropriate Content
To clarify the issue I was having: most devices lost their internet connection but remained connected to the WiFi. It seems to be a routing problem. Ethernet-connected clients were unaffected, but WiFi-only clients faced the issue.
- Copy Link
- Report Inappropriate Content
Hello!
I need help, after updating the firmware I can not print from my MacBook Air, Mac mini, however, I can print without problems from a pc with windows 11.
I already reset the Deco's network several times by changing the network name, uninstall and install my printers and the problem persists.
My printers are EPSON, before the firmware update they worked fine, now I can't print.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@G_Arora tried this way. But still having issues
- Copy Link
- Report Inappropriate Content
Hi,
I managed to resolve the issue by completely doing a factory reset and recreating the network, but please note that I still get some instances where the devices connected over wifi stays connected but do not have any Internet. I am hoping that a nee firmware will be released asap so that I can get rid of this issue. Plus I am regularly rebooting and scanning the network for interferences.
Best Regards,
G Arora
- Copy Link
- Report Inappropriate Content
@G_Arora hey thanks. But no luck for me. I tried 2-3 times with reset and the wifi gets disconnected for devices.
Finally 2 days back, I used the recovery tool to flash 1.4.x version and it is stable now.
I also noticed the v1.5.x not available anywhere to download. That means tplink might already aware about it now.
But it is sad to see they haven't announced anything official
- Copy Link
- Report Inappropriate Content
Information
Helpful: 4
Views: 1121
Replies: 11
Voters 3
