Px50 / P9 PLC/Eth Backhaul Combo

Px50 / P9 PLC/Eth Backhaul Combo

Px50 / P9 PLC/Eth Backhaul Combo
Px50 / P9 PLC/Eth Backhaul Combo
2024-10-19 09:21:07 - last edited a week ago
Model: Deco P9  
Hardware Version:
Firmware Version:

Hi friends,

 

I have a question, before I go ahead and make a purchase.

 

Currently have a P9 Powerline Deco setup in part of my house but have big thick stone walls, I need to add more units but want to use px50 because I would like the extra port in the main room. 

I know the px50 and p9 use different Powerline tech and are not cross compatible over Powerline but can you bridge that with ethernet Backhaul between the a px50 sattelite and a P9 sattelite?

 

My question is whether the below setup will work:

 

Px50 (Main Deco)<PLC CONNECTION> Px50 (Sattelite1)<PLC CONNECTION> Px50 (Sattelite2)

 

<ETHERNET>

 

P9 (Sattelite3)<PLC CONNECTION> P9 (Sattelite4)

<PLC CONNECTION> P9 (Sattelite5)

 

Essentially I only want to run one ethernet cable 

 

Thanks 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Px50 / P9 PLC/Eth Backhaul Combo-Solution
2024-10-22 10:29:57 - last edited a week ago

  @MorganTech 

Hi, welcome to the community.

For the topology:

Px50 (Main Deco)<PLC CONNECTION> Px50 (Sattelite1)<PLC CONNECTION> Px50 (Sattelite2)

 

<ETHERNET>

 

P9 (Sattelite3)<PLC CONNECTION> P9 (Sattelite4)

<PLC CONNECTION> P9 (Sattelite5)

 

The satellite P9 can't establish powerline backhaul with the main P9.

However, you could try to use satellite PX50 as the network source, and then create a new Mesh network with the extra 3-pack P9s.

How to Create a New Network in the Deco App

Thank you very much and best regards.

 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Px50 / P9 PLC/Eth Backhaul Combo-Solution
2024-10-22 10:29:57 - last edited a week ago

  @MorganTech 

Hi, welcome to the community.

For the topology:

Px50 (Main Deco)<PLC CONNECTION> Px50 (Sattelite1)<PLC CONNECTION> Px50 (Sattelite2)

 

<ETHERNET>

 

P9 (Sattelite3)<PLC CONNECTION> P9 (Sattelite4)

<PLC CONNECTION> P9 (Sattelite5)

 

The satellite P9 can't establish powerline backhaul with the main P9.

However, you could try to use satellite PX50 as the network source, and then create a new Mesh network with the extra 3-pack P9s.

How to Create a New Network in the Deco App

Thank you very much and best regards.

 

Recommended Solution
  0  
  0  
#2
Options