AV500 - Powerline Extender unable to change channel

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AV500 - Powerline Extender unable to change channel

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AV500 - Powerline Extender unable to change channel
AV500 - Powerline Extender unable to change channel
2015-10-26 20:49:41
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Hi everybody,

I recently purchased the AV500 Powerline Kit and set everything up. In general it works pretty fine, especially the H5R base station. This is set up to work on both 2.4Ghz and 5Ghz. You can see the configurations of both, the H5R and the H5E in the files attached below. As you can see the channels and the mode for the 2.4Ghz network on both devices are not the same:

For the base station it's:
channel 6
mode 11n only

For the extender it's:
channel 11
mode bgn mixed

The problem is, that I have a lots of other networks running on channel 11 and there are heavy interference with the mixed mode. I tried to sync extender and router several times but nothing changes. Although there is no option to change this through the web interface.

Is there any chance to change this?

Thanks a lot for your ideas and input,

Regards Matthias
File:
Unbenannt.pngDownload
Unbenannt2.pngDownload
  0      
  0      
#1
Options

Information

Helpful: 0

Views: 381

Replies: 0