One camera is showing only 1 wifi signal bar, while 2nd one is working properly
Hi everyone,
I have recently bought TP link security camera Tapo c120 pack of two. One is working fine but the 2nd one is showing low wifi signal strength. I rested camera and updated my mobile and also reboot my internet modem but the issue is still presist. Any help/support will be highly appreciated!
Thanks
Shariq
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
A camera's signal strength may be affected by several factors, such as environmental interferences, distance, and installation position, among others.
In your case, please try to swap the locations of the two cameras, and then check if the signal strength is weak when the first camera is installed at the 2nd camera's location.
If so, the weak signal strength may be caused by the installation environment rather than the camera.
By the way, on the Tapo app > camera's Device Settings > Device Info page, you can tap the Wi-Fi icon to see the detailed RSSI value to measure signal strength.
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
A camera's signal strength may be affected by several factors, such as environmental interferences, distance, and installation position, among others.
In your case, please try to swap the locations of the two cameras, and then check if the signal strength is weak when the first camera is installed at the 2nd camera's location.
If so, the weak signal strength may be caused by the installation environment rather than the camera.
By the way, on the Tapo app > camera's Device Settings > Device Info page, you can tap the Wi-Fi icon to see the detailed RSSI value to measure signal strength.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 176
Replies: 1
Voters 0
No one has voted for it yet.