TP-Link Community > Tapo Smart Camera > Viewpoint question
< Tapo Smart Camera

Viewpoint question

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Viewpoint question

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Viewpoint question
Viewpoint question
2025-08-18 01:12:26 - last edited 2025-09-17 12:04:34
Model: Tapo C220  
Hardware Version:
Firmware Version:

Is it possible to change the name of different viewpoints already set for a single camera. The descriptions were done by my son but they are not accurate at all! Is it possible to change them or must I remove that viewpoint and re-add it to accomplish this?

Please note I am not referring to camera name or device name. 
thanks. 
Michelle

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Viewpoint question-Solution
2025-08-18 12:48:46 - last edited 2025-09-17 12:04:34

  @MishL 

Hi,
It's unable to change the name of the viewpoint you've already added. If you do not want to change the viewpoint position but change its name, please try the following steps.
  1. Go to the camera's Live View > Pan & Tilt page.
  2. Tap the viewpoint you want to change its name.
  3. After the camera moves to that position, delete the viewpoint. Then add a viewpoint in the same position and set a different name for it.

Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> Enhance Your Tapo App Experience: Introduction to Several Practical Features >> Troubleshooting for Tapo Camera's Privacy Mode Automatic Activation
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Viewpoint question-Solution
2025-08-18 12:48:46 - last edited 2025-09-17 12:04:34

  @MishL 

Hi,
It's unable to change the name of the viewpoint you've already added. If you do not want to change the viewpoint position but change its name, please try the following steps.
  1. Go to the camera's Live View > Pan & Tilt page.
  2. Tap the viewpoint you want to change its name.
  3. After the camera moves to that position, delete the viewpoint. Then add a viewpoint in the same position and set a different name for it.

Best Regards

>> Smart Home: Introduction to Common Smart Action Scenarios for Tapo Cameras >> Tapo Camera Day/Night Mode Selection Guide: Best Settings Recommendations for Different Scenarios >> Enhance Your Tapo App Experience: Introduction to Several Practical Features >> Troubleshooting for Tapo Camera's Privacy Mode Automatic Activation
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 243

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.