Posição default da camera invertida
Ao ligar a camera ou restar ela, a posição padrão está com a lente virada para o lado da parede. Isso é um erro de montagem?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
After setting up your camera, if its lens is facing the side as the picture provided in this post, even after tapping the Pan & Tilt Correction button on the Tapo app > camera's Device Settings > Pan & Tilt page, I suggest contacting your retailer or our local support team to check if your camera is under warranty. Manually disassembling the camera may void its warranty.
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
You can refer to the QIG to install your TC40.
The position shown in the provided picture is not waterproof; we do not recommend using this position outdoors. If you need to invert the camera's image, please go to the camera's Device Settings > Video & Display page to enable the Invert Image option.
Best Regards
- Copy Link
- Report Inappropriate Content
Hi,
In fact, I don't want to invert the camera image via the application. With the image I attached, I tried to show that when turning on the camera, the default position is with the lens facing the side where the wall bracket will be fixed, different from what is shown in the installation manual. Watching some videos on YouTube, after turning on the camera, the default position of the lens is always forward, where there is the TAPO logo.
- Copy Link
- Report Inappropriate Content
Hi,
Typically, after the camera reboots, it will remain in the position it was in before restarting. If your camera's lens is facing the side where the wall bracket will be fixed after powering on, it may be that the lens was facing that side before powering on.
In the Tapo app > camera's Device Settings > Pan & Tilt page, please tap Pan & Tilt correction, then the camera will rotate to its default position.
Best Regards
- Copy Link
- Report Inappropriate Content
Recentemente adquiri uma câmera com o mesmo problema. Essa falha trata-se de um erro de montagem na fábrica, ficando o mecanismo de movimento vertical invertido em 180°. Caso você possua uma boa tolerância ao risco, esse erro erro é relativamente fácil de corrigir. Basta remover a capa de proteção branca da parte que gira na horizontal (4 travas de pressão internas, 2 em cada lateral), localizar o limitador que fica montado onde passam os cabos de alimentação, remover o 2 parafusos phillips, remover o limitador, girar o mecanismo de movimento vertical para a posição correta, remontar o limitador e remontar a capa de proteção.
- Copy Link
- Report Inappropriate Content
Hi,
After setting up your camera, if its lens is facing the side as the picture provided in this post, even after tapping the Pan & Tilt Correction button on the Tapo app > camera's Device Settings > Pan & Tilt page, I suggest contacting your retailer or our local support team to check if your camera is under warranty. Manually disassembling the camera may void its warranty.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 260
Replies: 5
Voters 0
No one has voted for it yet.