NX200 (v1) can't update firmware
Hi. I noticed a new firmware for the NX200v1 (Archer NX200(EU)_V1_1.8.0 Build 260311). I've tried to upgrade my router using that firmware file, but after reboot remains on firmware 1.7.0. v1.8.0 also doesn't show up when I check for upgrades under online upgrade.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
@Acinn Thank you for your reply.
@Cascine In your case, it's recommended to refer to Case 1 in the following instructions to update the NX200's firmware again. After you download the latest firmware for NX200 V1 from the official website here, please unzip it to get the .bin file.
How to Update Firmware on TP-Link Wi-Fi Routers
If the same phenomenon persists, please confirm the following information.
1. Please check the version info (EU, US, or other version) of your Archer NX200 v1. Usually, you can find it on the bottom label of the NX200.
2. Are there any error messages that appear during the upgrading process?
Best Regards
- Copy Link
- Report Inappropriate Content
@Cascine I updated to this firmware (from 1.7.0 Build 250904 ) using the manual process; the online update check has never worked for me, but I am guessing this is down to staggered roll-out.
Manually installing the update worked fine, but the firmware version reported once installed does not match the version specified on the download page - After updating to this my version shows: "1.8.0 3.0.0 v60a2.0 Build 260307 RC.19453n". The downloaded file is "Archer_NX200_EU1_v1_1.8.0 Build 260311"
Stupid question: You did extract the firmware file from the zip file before trying to install? :]
- Copy Link
- Report Inappropriate Content
Hi,
@Acinn Thank you for your reply.
@Cascine In your case, it's recommended to refer to Case 1 in the following instructions to update the NX200's firmware again. After you download the latest firmware for NX200 V1 from the official website here, please unzip it to get the .bin file.
How to Update Firmware on TP-Link Wi-Fi Routers
If the same phenomenon persists, please confirm the following information.
1. Please check the version info (EU, US, or other version) of your Archer NX200 v1. Usually, you can find it on the bottom label of the NX200.
2. Are there any error messages that appear during the upgrading process?
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 236
Replies: 2
Voters 0
No one has voted for it yet.