Tapo camera blinking red after brownout
After brownout the tapo camera blinking red status. As observed when the router and tapo camera all turn off the camera cannot reboot properly,then blinking red light displays. The sol. Is it reboot the camera. Is this a firmware update issue?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
Thank you for reaching out about your Tapo camera issue. To better help diagnose the problem, could you please specify the blinking pattern?
Is the red light slowly blinking (about once every 2-3 seconds), or is it fast blinking?
Also, have you already tried performing a hardware reset? If not, please try the following: How to Factory Reset Your Tapo Camera: Two Methods
If the reset doesn't resolve the issue, please refer to the official TP-Link community post below:
What to do if my Tapo Camera gets bricked after a firmware update?
If none of the suggested methods in the linked article work, the most effective next step is to contact your local TP-Link support for further assistance.
Best Regards.
- Copy Link
- Report Inappropriate Content
Hello,
Thank you for reaching out about your Tapo camera issue. To better help diagnose the problem, could you please specify the blinking pattern?
Is the red light slowly blinking (about once every 2-3 seconds), or is it fast blinking?
Also, have you already tried performing a hardware reset? If not, please try the following: How to Factory Reset Your Tapo Camera: Two Methods
If the reset doesn't resolve the issue, please refer to the official TP-Link community post below:
What to do if my Tapo Camera gets bricked after a firmware update?
If none of the suggested methods in the linked article work, the most effective next step is to contact your local TP-Link support for further assistance.
Best Regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 144
Replies: 1
Voters 0
No one has voted for it yet.