@Solla-topee 

Thank you for your support.

So far I have only received an email with Forum ID 261318, although this was initiated by Kevin_Z.

And one more thing, which I recently reported in the AX11000 beta firmware thread:

The first time I tried to connect an RE505X to OneMesh, I got an automatic notification in the router's OneMesh tab that there was a device ready to connect. On each successive attempt, however, I get this message, even though the RE505X is factory reset and ready to connect:

As a matter of fact, I'm carrying out another test as I write. The RE505X has been switched on for some 10 minutes now, but it still does not show up in the router's OneMesh tab as ready to connect (as it did the first time).

@Solla-topee 

@Maciej

So I have the same setup as @Maciej and have the same issue whilst testing the beta AX11000 onemesh firmware.

The Extenders appear to be connected in the AX11000 GUI but there is no internet connection between the AX11000 and the RE505X unless either unit it rebooted.

@Scott79 

Hi,

I can confirm your issue, however I think I have somehow got around it, at least partially. Here's how.

Previously, I was binding the IPs of both RE505Xs, as otherwise they would disappear (go off-line) and therefore become inaccessible. A few days ago, I reinstalled the AX11000 beta firmware from scratch, again (I think this may be important) and reconnected the RE505Xs but kept them on default settings (i.e. without any IP binding). I then rebooted the router, rebooted the RE505Xs, and was surprised to find that the RE505Xs stopped disappearing. As a matter of fact, they have not disappeared to date.

A part of the problem that remains, however, is that Tether has gone nuts. Namely, irrespective of whether my smartphone is connected to the AX11000 or to one of the RE505Xs, any attempt at connecting to the RE505Xs is met with a "cannot connect, try again later" message, while the AX11000 does not report all connected clients and does not allow me to change their icons. This appears to be a software issue, though, as I can connect to the RE505Xs through their web GUIs just fine.

Dear Sir/Madam

I have always failed connecting to cloud. It's show Request time out (With range extender Re505X)