Troubleshooting TP-Link Extender is not detecting the 5GHz Signal of the Main Router
This Article Applies to:
Dual-band range extenders, such as RE200/RE220/RE300/RE450/RE650, etc.
Scenario/Phenomenon:
- 5GHz frequency is not found when the extender scans for the host Network;
- The range extender does not detect the router’s 5GHz Wi-Fi/5Ghz Hotspot Wi-Fi.
** If the range extender detects the 5GHz Wi-Fi of the host router but fail to connect to it / the 5GHz LED is off after set up, refer to this FAQ.
Troubleshooting suggestions:
1. Locate RE closer to main router during set up.
2. Confirm router's 5Ghz Wi-Fi is working fine and available on other wireless clients (laptop, mobile phones etc.).
* If router's 2.4G & 5Ghz use the same SSID, please change a different SSID for 5Ghz to exclude the issue.
3. Change a different 5GHz wireless channel on the main router:
If the main router’s 5GHz channel is set to Auto or between 149-165, change it to a channel between 36-48.
Here takes the TP-Link router as an example, go to Wireless Settings >> 5GHz >> select a recommended channel, such as 48, then save and reboot the router.
Note: The 5GHz wireless settings will vary on different manufacturer’s routers, please contact your router’s technical support for help.
Notice for the (EU )Version TP-Link Range Extenders:
The range extenders with EU version, which can be verified by the device bottom sticker, only supports Band 1/2/3, they don’t support Band 4 channels on 5GHz to comply with CE certification in Europe. If your host Wi-Fi is fixed on Band 4 channels, the TP-Link range extender will not see it.
V Band1: 36-48 (36,40,44,48)
V Band2: 52-64 (DFS)
V Band3: 100-140 (DFS)
X Band4: 149-165 (149,153,158,161,165)
Related Articles:
1. For Huawei Router with Airtel, refer to the thread shared by our community user.
2. Brief introduction of DFS function.
Let the community know if you have any inquiries.