Deco X60 Blinking Red

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X60 Blinking Red

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco X60 Blinking Red
Deco X60 Blinking Red
2021-06-02 03:40:12
Model: Deco X60  
Hardware Version:
Firmware Version:

3 pack of Deco X60.  All been working good for the past few months.  Today, one of the units went off line and is blinking red.  Reset the unit, removed it from my devices and now I can not get it to blink blue to add it again.  I have tried resetting it several times with the "reset" button on the bottom of the unit.  Suggestions?

  0      
  0      
#1
Options
1 Reply
Re:Deco X60 Blinking Red
2021-06-03 06:19:25

@cnb2360 

Hi,

After you reset the satellite Deco and set it up again, what happened now? Were you able to set it up successfully then it dropped again?

Since there are two satellite units, have you tried to swap their location and check whether it was always the same unit that dropped the connection?

Thank you very much.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1001

Replies: 1

Related Articles