Configure Router as AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Configure Router as AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configure Router as AP
Configure Router as AP
2022-10-26 18:23:43 - last edited 2022-12-02 09:30:04
Model: Archer C80  
Hardware Version: V1
Firmware Version:

Hi,

 

I just purchased a new router from TP-Link, Archer AX72.

I wanted to convert my old router Archer C80 into a mesh device.

I have changed the operating mode to AP mode and tried to configure it to connect to the wifi, but couldn't find anywhere how to do that.

Can anyone explain how this is done?

  0      
  0      
#1
Options
1 Reply
Re:Configure Router as AP
2022-10-26 19:10:28 - last edited 2022-10-26 22:04:20

  @Israel89 

 

You can't have two routers in OneMesh - check OneMesh FAQ - Q8/A8 and Q10/A10.

You can have C80 in AP mode (Case 1), connected to AX72 with an ethernet cable.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options