Changing the nat type to moderate or open on the Archer AX53
Changing the nat type to moderate or open on the Archer AX53
So i want to change the nat type for a better online gaming experience, but i tried a lot of things but none of them worked, i might be missing something.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@woozle t-mobile, sorry for the late response my internet went down yesterday
- Copy Link
- Report Inappropriate Content
Ok, so you have a 4G/5G router with a SIM card and mobile data plan from T-Mobile, right?
If that was the case, then I think there is very little chance for you to get a public IPv4 address that would allow you to have an open NAT type. Mobile carriers were among the first to stop providing public IPv4 addresses to their customers and use CG-NAT instead.
But you could still contact T-Mobile and ask them if they are able to provide a solution to you. Maybe you are lucky.
- Copy Link
- Report Inappropriate Content
@woozle i contacted them and i can't. do you think that buying a router that i can use a sim with will fix my problem?
- Copy Link
- Report Inappropriate Content
If the Internet provider has implemented a CG-NAT at their side, then there is nothing the router at home can do about it.
- Copy Link
- Report Inappropriate Content
@woozle but when i had an lte router my nat type was moderate?
- Copy Link
- Report Inappropriate Content
Was that LTE router used with the same T-Mobile contract? If you still have that LTE router, then perhaps it would be best to revert back to your old Internet setup if it allowed moderate NAT.
- Copy Link
- Report Inappropriate Content
@woozle It was a temporary replacement from t-mobile and i don't have it anymore.
- Copy Link
- Report Inappropriate Content
Hi@mapp,
We're thrilled to announce the release of the pre-release firmware for Archer AX53/AX58 V1. This firmware update introduces several exciting new functions and improvements to enhance your experience including Ethernet Backhaul, EasyMesh in AP mode, Satellite Router Management, ECO Mode, etc. We encourage you to try out this version of firmware and take advantage of the following features. Your feedback and suggestions are greatly appreciated.
Pre-release Firmware for Archer AX53/AX58 Supports EasyMesh in AP Mode, Ethernet Backhaul, ECO Mode
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 723
Replies: 18
Voters 0
No one has voted for it yet.