Can configuration confirmation/rollback be added to the omada controller, so that if you change the configuration and it breaks connectivity to the omada controller it will be rolled back. Or maybe...

Does it take a while for the topology view to sort itself after a change has occurred? Replaced a Netgear switch with a TL-1500G-10ps and I'm seeing some oddities in the topology view like my office...

@Fae For point 6 you may want to state that wireless mesh is supported on some models. but you need the controller and at least ONE of the AP's must be wired to the ntework.

I ordered 2x TL1500G-10ps with the hope that I'd get ones that support Omada, I actually recieved a single TL-SG2210P v3 which it seems was upgradable to a TL-SG2210p V3.20 via a firmware upgrade...

Just tried out of curiosity tried disconnecting the uplink from one of my switches that has an EAP-225 connected, I then enabled wireless uplink/mesh in the controller to reconnect the now isolated...