@Collinfranco you also dont need a gateway ACL permitting wan>lan for stuff you have a port forward set up for - it will just pass it through. The ACL might actually interfere

@NoMadMan As long as all your devices and clients are downstream of the switch, you can prevent this in the future by enabling this option in vlan settings

@AndyHarrowven That particular "acess point" isnt vlan aware so you only get one vlan out of it and no central control. There are some inexpensive EAP models that will fully work with Omada

@NoMadMan The controller doesnt have anything to do with DHCP, that is all coming from your Gateway Make sure your switch ports and VLAN trunking are in order, bearing in mind the new switch profile...

I just tested this on my OC200 v1 used for testing - Downgraded it to 5.15.24 official - Let it boot, then pin-hole reset to be sure its "reset" fully - On reboot, do initial wizard but not restore...

@AndyHarrowven You could put an omada gateway in the place of the switch downstream of the starlink (top, middle in the diagram), put the starlink in bridge mode and have the omada gateway manage all...