@Frosch1482 You need to edit and clarify your post. You state that the MGMT VLAN ID is 10 and later you state that it is 20. It's confusing.

@Jropes Understand... Let's see what the moderators have to say on this issue. I have 3 EAP650-Desktop APs here and there hasn't been any firmware updates lately which may fix your problem.

Jropes wrote hi everyone, as per the title I'm getting a strange issue where when I have the Root AP as the EAP 650 desktop, the child AP(eap610) has slow wireless speeds where it crawls down to...

@Ethan-TP Upgraded 2 of 4 SG2008 v4.20 switches successfully. The other 2 switches had the following configuration failure result: Apply Again did not clear the error on either switch. Doing a Force...

@Tournas Only guessing here... I would create an IP-Port group with the Tuya device subnet and port 6667 and use it as the source in a Deny ACL. For the destination, I would try IPGroup_Any to see...

@Cyberwasp As @GRL pointed out, if you decide to configure the NAS ports into a LAG group, you need to select Balance XOR (as shown below) instead of the default setting.