@Vincent-TP Yes, exactly the same. Currently only one of the EAP650-Desktop devices is showing the incorrect number of entries (3 instead of 2) and the EAP610 is displaying 5 entries as shown below:

@Omdd1 The ETH1, ETH2, and ETH3 ports on the EAP650-Desktop can be configured for different VLANs. By default, they mirror whatever is incoming on ETH0. In the controller window, go to Devices, click...

@Vincent-TP Since several days ago, I now have the issue again with my EAP610 V3 access point. When I made the switch from multiple SSIDs to a single SSID (on each band), I renamed the initial PPSK...

@ITV It is true that the factory defaults for Omada devices are to use VLAN 1 and the 192.168.0.1/24 subnet. However, it is relatively easy to change this and the system works quite well as long as...

@Krusing If both sensors have the same local IP address, the gateway will always see an IP conflict. I would place another (inexpensive) router between the gateway and one of the sensors which would...

@ITV , This is getting complicated. If there are two interfaces for each VLAN, then an ACL is needed for each interface. A deny rule is needed to prevent the VLAN(s) from accessing other VLANs. One...