@dononeil I haven't found anywhere where you can find which devices have lock to ap. My solution was to add _lock to the device name to be able to search for these devices.

@dononeil I had the same problem but I use rate control, it works pretty well. Even if the signal is bad the speed should be at least 24 Mbps and that is good enough for most IoT devices. if the...

@mtv890 router acl will not work on wireguard traffic, however you can use switch acl which will work against lan devices. with switch acl you can use ip and port groups you cannot do that with...

@ILNT If it's not your access point, you have a neighbor who has access points that have lost contact with the controller and are trying to mesh with you. If you don't use mesh, you can disable this...

@Vincent-TP It's all good again now. There were a couple of hours yesterday when it was just a white page, everything is working again now

@OZ-ZERO I don't know if there is a DNS proxy in stand alone but in theory you can use an ER605 in front of the router you have today,