Long story short, I have 4 Deco M5 units in the house. 3 of them work fantastic but I have one that is plugged in directly with cable that runs in the basement to the other side of the house. The devi

I have 3 access points. Connected to the local network via ethernet. When all 3 points are turned on, they connect to each other via Wi-Fi and begin to output network back via ethernet, thereby hangin

Hi all, My setup: Inside the house: Modem ISP ---cat6_cable---> Deco P9 (configured as main in router mode) ---cat6_cable---> switch (to provide internet to wired devices) Also spread in the house: 4

I think the problems started begone after the last update. My setup, I have a cable modem in bridged mode, connected a 1GB/S Router (disabled wifi) and when the Deco's M4 (AP mode) are connected with

Hi! Wanting to buy the XE75's, but my router doesn't have a bridge mode. It has my VOIP phone connected, and I can't loose that. So wondering what the solution is.. I assume I can't just replace my IS

We have a hardwire connection between two buildings in the same mesh network. We have an excellent WiFi coverage in both buildings but the internet bandwidth is limited from house nr two. One of the m