Please excuse what some might take as stupid question but I am 88 and have little i/t knowledge. I have just installed Deco M9 Plus Mesh system to my AC4000 router. Main disc is about 3 ft from floor

Hello, I've just bought the router to replace the rented FunBox 2 from my ISP. I've managed to connect it through ADSL2, but when I try to make a VDSL connection, in the Internet Connections tab the s

Hi, Just installed a Omada OC200 controller with two EAP225 WiFi access points connected to an 8Port POE TP-Link Network Switch. The switch is connected direct to a BT Router Smart Hub2. Problem is th

I got the OC200 to adopt the R605. That was fine. The DHCP pool set up is different. On my MikroTik I have a range of ...100-254, and I set static IPs outside this pool. This is what I set on the cont

I have just purchased this EAP235-Wall device to become part of a setup mixing EAP110, EAP115 and EAP225 devices. I am using software controller v3.2.7 as the latest version supported by the oldest AP

Good morning all, I have 2 questions about the operation of EAP225-V3: 1.) I've been running an EAP225 on my DSL router (Fritzbox 7390) for a bit longer and very reliably, but after a move, to increas