Environment: Omada Software Controller v6 EAP655-Wall, EAP725-Wall (and likely other EAP models) AP in controller mode, DHCP active Steps to reproduce: AP → Config → IP Settings DHCP mode: leave uncha

I have two of the TP-Link TL-SG108S-M2 connected over CAT 6 Ethernet (approx 60-80 feet) and have various 100 Mbps, 1Gbps, and 2.5Gbps devices connected on both switches. On one switch the 2.5Gbps dev

Good afternoon. The controller logs accumulate approximately 4 million messages per day containing the following content: WARN [https-jsse-nio-8043-exec-3] [] c.t.s.o.m.d.d.m.s.i(): OmadacId(<OMADA _I

Good day Everyone, Maybe someone can shed some light on this and maybe i am not the only one that is facing this problem. Setup: Site A: LAN: 192.168.0.0/24 No-IP: dyndns1 Bridged modem connected to a

Im using my own software controller hosted on VPS. Im running in MSP and currently running 6.2.0.15. Im curious to know how this remote access feature work, I look at the document it support software

I have just downloaded and upgraded to 1.33.9 Build 20260401 Rel.45256 firmware version for Omada Controller OC300 v1. Everything operates OK so far. But after installation I noticed that it is marked