Smart Home Community > Kasa Smart Bulbs > smart bulbs not resetting
< Kasa Smart Bulbs

smart bulbs not resetting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

smart bulbs not resetting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
smart bulbs not resetting
smart bulbs not resetting
2019-10-10 20:18:53

Hi guys can you help 

 

Had a fault with my router and virgin came and swapped out my router ...

 

now none of my bulbs are working i tried performing a soft reset and a hard reset but the bulbs will not blink 

 

i had a brand new buld that i have installed and that works perfectly also the 2 smart plugs that i own have been fully reset and are working again on my network 

 

 

so what am i doing wrong ..

 

i have followed the instructions for reset from the new bulb 

 

and still not working or blinking 

  0      
 
  0      
 
#1
Options
3 Reply
Re:smart bulbs not resetting
2019-10-10 20:30:32

@lee.rob 

 

Make sure when you turn it on/off that you see it going on and off.

You maybe doing it too fast.

  0  
  0  
#2
Options
Re:smart bulbs not resetting
2019-10-12 08:34:50

@lee.rob 

 

What is the model number of the smart bulb? 

 

Please turn it on and off for 5 times at a slower rate to hard reset it. 

 

If still does not work, try to power cycle it or change another lamp base to install it.

 

May it help and have a nice day. 

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#3
Options
Re:smart bulbs not resetting
2019-10-29 16:56:24

Hi

One thing I found was that the flashing phase takes a good 10 seconds to establish after the last on/off sequence@lee.rob 

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 2114

Replies: 3

Related Articles
 New to Smart Bulbs!
755 0
 Smart Bulbs Question
531 0
 Smart Bulbs Question
842 0
 Controlling Smart Bulbs
639 0
 Smart bulbs in the U.K.
1045 0
 Kasa Smart bulbs
414 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.