Bulb Not blinking at all

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bulb Not blinking at all

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bulb Not blinking at all
Bulb Not blinking at all
2019-10-26 10:57:16
Model: LB100  
Hardware Version:
Firmware Version:

No matter what I do, my bulb will not blink. I have tried a different lamp, tried resetting it, tried flicking switch multiple times among others.

 

I have absolutely no idea what has caused it, but it just does not work. Initially, it was fine for a few weeks, but then it just disconnected from the app and now refuses to blink.

 

Any help would be appreciated.

  0      
  0      
#1
Options
1 Reply
Re:Bulb Not blinking at all
2019-10-29 10:33:52

@flynn4051 

 

Hello, make sure that you turn it on and off for 5 times at a slower rate. Still the same thing, you can contact the retailer or the tech support to get the warranty service. 

https://www.tp-link.com/support/contact-technical-support/#E-mail-Support

Note: Please provide the troublehsooting you have done, the serial number of the LB100 and the proof of purchase.

 

May it help and have a nice day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options