Smart Home Community > Tapo Smart Camera > My camera is no longer connecting to network after I changed the network password
< Tapo Smart Camera

My camera is no longer connecting to network after I changed the network password

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

My camera is no longer connecting to network after I changed the network password

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My camera is no longer connecting to network after I changed the network password
My camera is no longer connecting to network after I changed the network password
2020-02-24 03:19:32
Model: NC450  
Hardware Version:
Firmware Version:

Camera was working fine until I changed wifi password and now can't seem to connect even after pressing the WPS button on both modum and camera. Any ideas??

  0      
 
  0      
 
#1
Options
4 Reply
Re:My camera is no longer connecting to network after I changed the network password
2020-02-24 10:25:36

@nth 

Hello, it is suggested to hard reset it by holding the reset button for 10s first.

 

Then you can use the tpCamera app to configure it with the new wifi password. 

https://www.tp-link.com/support/faq/821/

 

May it help. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options
Re:My camera is no longer connecting to network after I changed the network password
2020-02-25 04:37:46
Thanks I tried that and no luck :(
  0  
  0  
#3
Options
Re:My camera is no longer connecting to network after I changed the network password
2020-02-27 10:24:46

@nth Hello, it is suggested to hard reset it by holding the reset button for 10s first.

https://bestmicrowaveoven.xyz/
  0  
  0  
#4
Options
Re:My camera is no longer connecting to network after I changed the network password
2020-03-05 06:04:55 - last edited 2020-03-06 00:28:32

@nth 

Hi,

Please make sure you factory reset the camera successfully, can you see the light change when you press the reset button on the camera? If the light has no change, restart the camera and reset it again.

 

If you can factory reset the camera, which steps that you can not get through? Is there any error message on the app?

 

Good day.

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 800

Replies: 4

Related Articles
I can not see the camera in Camera Control
985 0
SMTP connection to smtp.gmail.com no longer supported by Google (Replaced by oAuth)
315 0
Home Camera
342 0
TP Camera App on tablet failed to connect through cloud to camera
336 0
Camera is not connecting with Wifi
383 0
 Bulb no longer connecting
461 2
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.