Camera hub keeps playing "Jingle bells" on detection - cannot change
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Just installed Tp-Link H200 but all detections give a continuous "jingle bell" tune - I have tried to change this and sound duration without success? I would really appreciate any advice? Thanks Tony
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Thank you for the feedback. If you're using the smart action feature to trigger hub alarm, please configure the siren (ring tones) in the smart action rule. The settings on the H200 page take effect when you control it manually.
- Copy Link
- Report Inappropriate Content
@toymaker Did you get this resolved as mine is doing the same.
- Copy Link
- Report Inappropriate Content
What's the hardware and firmware version of your H200? Please send me its Mac address via PM. (Locate the device info in the APP ->H200 ->Device Settings ->Device Info)
1. Please check if you have created any Smart Action rules (Automation or Shortcut) to trigger the hub to ring.
When the hub is set as an Action device (When xxx, Then Control H200 to Ring), there is a custom Siren Sounds option in the settings, and the ringtone configured there will be different from the hub's default ringtone.
2. Modify the Ring Tone under the local network to avoid unsuccessful changes due to network fluctuations. After that, try using "Play Ring Tone" immediately to observe if the ringtone has been successfully modified.
If the problem exists, please reproduce the problem and make a video, I'll pass it to the senior engineer to check it.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 1986
Replies: 4
Voters 0
No one has voted for it yet.