Smart Home Community > Tapo Smart Camera > Tapo C510W No PTZ Profile after firmware update (1.3.1)
< Tapo Smart Camera

Tapo C510W No PTZ Profile after firmware update (1.3.1)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tapo C510W No PTZ Profile after firmware update (1.3.1)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tapo C510W No PTZ Profile after firmware update (1.3.1)
Tapo C510W No PTZ Profile after firmware update (1.3.1)
2025-02-02 20:01:57 - last edited 2025-02-08 19:11:40
Tags: #Firmware #ONVIF/RTSP
Model: Tapo C510W  
Hardware Version: V1
Firmware Version: 1.3.1

Hello,

 

after the update to firmware 1.3.1, I cannot use PTZ on my camera via HomeAssistant (the error shows no ONVIF profile).

 

Checked the forum for similar problems, and I found that there is a problem, but the thread is about C500.

 

I would like to know if a firmware update for C510W exists. Thanks!

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Tapo C510W No PTZ Profile after firmware update (1.3.1)-Solution
2025-02-08 08:47:21 - last edited 2025-02-08 19:11:40
▶ CES 2026 Meet TP-Link AI Assistant and More New Products!
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:Tapo C510W No PTZ Profile after firmware update (1.3.1)-Solution
2025-02-08 08:47:21 - last edited 2025-02-08 19:11:40
▶ CES 2026 Meet TP-Link AI Assistant and More New Products!
Recommended Solution
  0  
  0  
#2
Options
Re:Tapo C510W No PTZ Profile after firmware update (1.3.1)
2025-02-08 19:11:37

  @Wayne-TP Thanks for the info!

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 752

Replies: 2

Tags

Firmware ONVIF/RTSP
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.