Latest firmware has ruined my C220.
Latest firmware has ruined my C220.
Hello.
I have two Tapo C220 cameras and both have been working just fine. However last night one of the cameras decided to auto update the firmware to the latest 1.3.1 and now the camera acts like it's running 1-2 fps at best. This is the live video and anything recorded. The whole thing has turned into an unusable slideshow. The other C220 is still on firmware 1.2.5 and it still running fine as normal (I switched off auto update for this one now)
I tried swopping the camera positions of the two C220s and that didn't help. The one on 1.3.1 is a slideshow no matter where it's positioned. I checked the framerate and both are set to the usual 25fps. It must be something from the update that has caused this so how can I revert back to the previous 1.2.5? Any help appreciated.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Souvik543 Go into the camera's settings and choose Advanced Settings and then under Display Settings you should see Compatible Mode.
- Copy Link
- Report Inappropriate Content
- Had no problems with my C200 for about 1.5 years until September 19, 2025
- Then a firmware update came along and the camera could no longer log into my Wi-Fi (WPA2 / WPA3).
So, here's the thing:
I bought a new C220, and this camera immediately set up with my Wi-Fi configuration above.
- The app version is, of course, also 3.13.818
- However, the camera is still on firmware 1.2.1! And it will stay there ;-) I've disabled automatic updates because I suspect the problem was caused by firmware 1.3.
- Copy Link
- Report Inappropriate Content
Hi,
Please check the hardware version of your Tapo C200. Is it V3? If your Tapo C200 V3 can't connect to your Wi-Fi after a recent firmware update, please try setting your Wi-Fi's security type to WPA2-PSK only and then check if it helps.
Best Regards
- Copy Link
- Report Inappropriate Content
After an auto update to firmware 1.4.3, my C200 v3 cannot connect to wpa2/wpa3 network anymore. So I bought a C220 which was still on firmware 1.2.1 and the connection to wpa2/wpa3 network does work!
Then, I setup a seond router, set the wifi to wpa2 only and the old C200 could connect immedeately, even with firmware 1.4.3
THIS IS NOT A SOLUION FOR ME! Some of my devices nd wpa3
Please fis as soon as possible or just put firmware 1.4.2 or 1.2.1 back. Therewas nothing wrong with it
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 1680
Replies: 14
Voters 0
No one has voted for it yet.